Kitchen Cabinets To Ceiling With Crown Molding

Place the crown molding so that it is rests upside down and at a 45 degree angle against the saw fence.

Kitchen cabinets to ceiling with crown molding.

If there are small gaps above the wall cabinets this can usually be easily filled with crown moldings or other decorative trim work. For any cabinets with an inside corner cut the miters with the opposite 45 degree angle so that the miter angles on the crown molding cut into itself. Make sure the pieces are together and in place snugly. Measure and cut the crown molding front section.

Here is the same kitchen with a riser molding added below the crown molding which takes the cabinets all the way to the ceiling. It all is one continuous piece from the cabinets up to the crown molding. Our kitchen ceiling is 10 at the highest point inside the tray. Crown molding from cabinet top to ceiling many of the kitchens we work in have the ceilings up to an inch or so out of level so to simply do a crown on top would be near impossible.

Use a pin nailer to nail into the corners of the two pieces of crown molding image 2. The molding also comes in handy for closing the gap between the top of the cabinets and the ceiling and for creating a unified appearance and style along the sight line near the ceiling. We were extending the crown molding into the kitchen that we put up in the rest of our first floor and wanted to take the time to add height instead of just running the crown molding behind the cabinets. The perimeter of the room is 9.

Here is a working drawing of a kitchen with an 8 ft ceiling. Set the miter saw to a 45 degree angle cut. This project is easy to do. Measure and mark the front section of crown molding to the cabinet width.

Using a nail gun nail the crown to the baseboard. What we usually do in this instance is to take the cabinets up to 6 from the ceiling. The riser molding is outlined in red. If you have unusual ceiling heights a custom cabinetry specialist can build cabinets to fit any space which may be the most practical solution if you have 10 foot high ceilings.

Https bit ly 2cholxk sweet new drone https amzn to 2sp3vqg the fancy glue i used. Repeat this process with the rest of the cabinets with outside corners. Mount the crown molding to the cabinet using the brad nailer. Cut at one mark then move the molding along to the next mark.

We didn t want our cabinets to go clear up to 9 so our custom cabinet maker added a soffit that matched the cabinets.